Updated Configuration Variable Value not showing in the logs
Posted: August 31st, 2023, 9:16 am
Updated the Branch Plant configuration value in PD, Config value shown below, '480440' was added
When running the source that pulls the ApprovedBranchPlantList value, we're getting the old value in the logs. This fixed it by saving the values again, ran into this issue yesterday as well.
- ConfigVariables.png (6.37 KiB) Viewed 2994 times
- ConfigVariables.png (6.37 KiB) Viewed 2994 times
When running the source that pulls the ApprovedBranchPlantList value, we're getting the old value in the logs. This fixed it by saving the values again, ran into this issue yesterday as well.