Binary Decision displays != operator wrong

[msweeney]

I noticed the != operator value is displayed wrong in one place in Binary Decision services.

It displays correctly in most cases, both in the code editor on the right and the "card panel" on the left (is there an official way to refer to that panel of the UI?). The code editor displays it incorrectly, though, when the "Test #{N}" card is selected and its XML content is displayed.

[SteveCap]

Task #10281 has been created. This post will be updated when it has been completed.

[JustinVanRegenmorter]

This issue has been resolved as of DesignTime Revision 2254.